Installing Post and Lantern Lights- Part 5 of 7

• Dig a hole about 2′ deep with an ordinary post hole digger or tiling spade. Run cable up through the lamppost, then fill the hole with about 12′ of concrete mix. Insert the lamppost into the concrete mix in an upright, plumb position. Use a long level or plumb bob to make sure the lamp is exactly straight. Remember, you cannot straighten it after the concrete hardens.
• Use a bent piece of conduit to protect the turn in the cable below the post (see image). This eliminates the danger of trouble at the turn.
• You may want to use temporary stakes and guy wires to hold the post lantern in an upright position until the concrete dries. Using four guy wires in opposite directions ensures a secure post.
• After the concrete is completely dry, fill in the hole with dirt and seed around the post for a neat appearance.

Check your state and local codes before starting any project. Follow all safety precautions. Information in this document has been furnished by the National Retail Hardware Association (NRHA) and associated contributors. Every effort has been made to ensure accuracy and safety. Neither NRHA, any contributor nor the retailer can be held responsible for damages or injuries resulting from the use of the information in this document.

For home improvement advice, visit JS West Lumber & Ace Hardware Sonora, Ca. or visit www.acehardware.com and click on the Answers@Ace icon. Answers@Ace is an online resource with information for do-it-yourselfers about hardware and home improvement projects. The Everyday Projects section has pictures and detailed, step-by-step instructions for this and many more home improvement projects.

To speak to an Ace Hardware advisor in Sonora call: 209 532 7446.